Climax H&S TOOL SPEED FACER ODF100, Operating Manual

Page: 72 / 132

Page 54 ODF Speed Facer Operating Manual
3. Lower the machine carefully. Referring to Fig-
ure 6-1, align the arrow with the notch in the
pivot support when setting the Speed Facer
onto the shipping frame.
F
IGURE
6-1. A
LIGNMENT ARROW
(ODF80
SHOWN
)
4. With the machine frame resting in the pivot
saddle, continue lowering the machine, allow-
ing it to lean back to the same angle as the
inclined shipping frame.
5. Loosen the screw marked as A in Figure 6-2, and
then adjust the screw marked as B to approxi-
mately 50 in-lbf (6 Nm).
6. Repeat step 4 with the other lower outside set
of A and B screws on the frame. This provides a
uniform support of the machine frame.
F
IGURE
6-2. O
UTSIDE SCREW LOCATIONS
(ODF80
SHOWN
)
7. Adjust the inner ring supports (see Figure 6-3) in
the same manner as step 4 and step 6 to sup-
port the machine track ring and prevent roller
damage during transport.
8. Secure the machine to the inclined shipping
frame using the ratchet straps between the
hoist ring, shown in Figure 6-3, and the strap
attachment point.
F
IGURE
6-3. H
OIST RING
,
STRAP ATTACHMENT POINT
,
AND INNER RING SUPPORTS
(ODF80
SHOWN
)
ALIGNMENT
ARROW
A
B
STRAP
ATTACHMENT
POINT
HOIST RING
INNER RING
SUPPORTS