Climax H&S TOOL SPEED FACER ODF100, Operating Manual

Page: 67 / 132

P/N 102615, Rev. 0 Page 49
F
IGURE
5-4. I
NITIAL ROLLER BEARING LOCATIONS
4. Place the roller adjusting wrench over the
eccentric bushing and loosen the lock screw
with a 5/16" Allen wrench. Apply a preload to
these four rollers that will allow the machine to
be rotated by hand with some resistance. The
recommended torque setting for the eccentric
bushings at these four locations only is 7ft-lb
(9.5 NM)
F
IGURE
5-5. A
DJUSTING AND TIGHTENING OF THE BUSHINGS AND CAP SCREWS
5. Tighten the lock screw while maintaining the
position of the eccentric bushing with the
adjustment wrench. The recommended torque
setting for the socket head cap screws at all
roller bearing locations is 50 ft-lb (67.8 Nm).
6. Reinstall the air motor and activate the
machine rotation. Adjust the speed to approxi-
mately 2-4 RPM.
7. Adjust the remaining intermediate rollers to
make contact with the track ring. These rollers
should be adjusted 180° to each other while
working around the machine. The recom-
mended torque setting for the intermediate
bearings is 3 ft-lb (4.1 Nm).
NOTICE
It is normal for some of the intermediate rollers to
only rotate intermittently.
8. Check for play between the stationary frame
and the rotating track ring by inserting a pry bar
device between the edge of the frame and the
track ring. If movement is detected while apply-
ing pressure, repeat steps 3-7.
9. Apply anti-seize to the bearing surface of the
ring gear and rollers as noted in Table 5-2.
10. Replace all guarding and the trip actuator.
5.3.9 Trip cable replacement
Do the following to replace the trip cable in the event it
breaking or becoming damaged.
5.3.9.1 Cable removal
To remove the cable, do the following on the feedbox:
1. Remove the cover and set screw guarding the
M4 fastener.
2. Set the feed adjustment screw to maximum by
turning the screw all the way in.
F
IGURE
5-7. L
OCATION OF
M4
SCREW
(
LEFT
);
CABLE END UNDER
M4
SCREW
AND JAM NUT WITH ADJUSTING BOLT
(
RIGHT
)
3. Loosen the M4 screw to free the cable end.
F
IGURE
5-6. C
HECKING FOR PLAY BETWEEN THE TRACK RING AND THE STA
-
TIONARY RING