Climax H&S TOOL SPEED FACER ODF100, Operating Manual

Page: 53 / 132

P/N 102615, Rev. 0 Page 35
c) Using the leveling jaw adjustment screw,
raise or lower the jaw half the difference
between the two feet.
d) Repeat step b and step c for the remain-
ing leveling feet. Typical applications
require machine alignment within 0.010"
(0.25 mm) or less.
F
IGURE
3-8. D
IAL INDICATOR MOUNTED FOR LEVELING
4. Alternating between the four adjustable jacking
feet, torque to 140 ft-lbs (190 Nm).
WARNING
Be sure to tighten the jacking feet to 140 ft-lbs (190
Nm) minimum. Insufficient clamping force may
allow the machine to fall from the workpiece,
which may result in machine damage or personnel
injury or death.
NOTICE
Do not over-tighten the jacking feet screws. Over-
tightening could warp the machine rotational frame
and cause undesirable machining results.
5. For the ODF50 through ODF120 models only:
Alternating between the four non-leveling feet,
torque to 140 ft-lbs (190 Nm).
6. Tighten the jam nuts on all jacking feet.
7. Remove the setup fingers from the leveling
feet, if necessary to machine completely to the
OD. See Section 3.3.1 on page 31, Section 3.3.2
on page 31, and Section 3.3.3 on page 32 for
information for securing the machine.
3.4.4 Installing the cutting bit or insert
holder
NOTICE
The ODF Speed Facer is designed to drag the cutting
tool behind the bridge weldment or backing facing
attachment. Refer to the rotational direction label
on the machine when installing the cutter.
Do the following to install the cutting bit or insert
holder:
1. Adjust the tool holder to the correct position
for the start of machining.
2. Adjust the tool holder to the desired swivel
angle (see Figure 3-9).
F
IGURE
3-9. L
OCATION OF SWIVEL CLAMPING SCREW
3. To install the appropriate tool in the swivel tool
post: Loosen the M20 tool clamp screw, insert
the cutting tool, and tighten the M20 screw.