C0240111-04-05-GB
4)
Set the required address (e.g.: 1 )
To do this, press [UP] or [DOWN]; press [ENTER] to confirm.
pLan address: 1
UP: increase
DOWN: decrease
ENTER: save & exit
5)
An “empty” mask appears because the address of the keyboard
is 0 and that of the card is (for example) 1; the two devices
therefore cannot communicate. Disconnect the power supply
from the card (N.B.: the address set for the keyboard will not
be reset)
6)
Set the keyboard address (see para 3.4.1): do not set it to zero
or to an address that is already used in the previously set card.
When the keyboard address is set, a blank mask appears.
7)
Repeat the keyboard address setting procedure but this time
set the “I/O card address” field with the address number used
for the card. A mask similar to the one shown to the side will
appear.
Terminal Config
Press ENTER
To Continue
8)
Configure the plan network (see para 3.4.4).
3.4.3 “L”, “XL” AND “E” CARD SETTINGS
1)
Make sure the card is disconnected from the power supply
2)
Set the required address using the dip-switches (see below)
3)
Set the keyboard address (see para 3.4.1)
4)
Configure the plan network (see para 3.4.4)
In this case set the card address with the following dip-switches:
ON
1
2
3
4
5
6
DIP
ON
1
2
3
4
DIP
Cards “L”, ”XL”
Cards ”E”
Table of possible combinations: (0 = off, 1= on)
Dip-switch setting
1
2
3
4
5
6
Address
0
0
0
0
0
0
0
1
1
0
0
0
0
0
2
0
1
0
0
0
0
3
1
1
0
0
0
0
4
0
0
1
0
0
0
5
1
0
1
0
0
0
6
0
1
1
0
0
0
15