19-4
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
78-13315-02
Chapter 19 Checking Port Status and Connectivity
Checking Port Capabilities
Port Status Channel Admin Ch Neighbor Neighbor
Mode Group Id Device Port
----- ---------- --------- ----- ----- ----------------------------------- -----
1/1 connected auto 65 0
Port Align-Err FCS-Err Xmit-Err Rcv-Err UnderSize
----- ---------- ---------- ---------- ---------- ---------
1/1 0 0 0 0 0
Port Single-Col Multi-Coll Late-Coll Excess-Col Carri-Sen Runts Giants
----- ---------- ---------- ---------- ---------- --------- --------- ---------
1/1 0 0 0 0 0 0 0
Last-Time-Cleared
--------------------------
Tue Jun 8 1999, 10:01:35
Console> (enable)
Checking Port Capabilities
You can display the capabilities of any port in a switch using the
show port capabilities
[[
mod
][
/
port
]]
command.
This example shows you how to display the port capabilities for switch ports:
Console> (enable)
show port capabilities 1/1
Model WS-X6K-SUP1A-2GE
Port 1/1
Type No Connector
Speed 1000
Duplex full
Trunk encap type 802.1Q,ISL
Trunk mode on,off,desirable,auto,nonegotiate
Channel yes
Broadcast suppression percentage(0-100)
Flow control receive-(off,on,desired),send-(off,on,desired)
Security yes
Membership static,dynamic
Fast start yes
QOS scheduling rx-(1p1q4t),tx-(1p2q2t)
CoS rewrite yes
ToS rewrite DSCP
UDLD yes
Inline power no
AuxiliaryVlan no
SPAN source,destination
COPS port group 1/1-2
Console> (enable)
Using Telnet
You can access the switch command-line interface (CLI) using Telnet. In addition, you can use Telnet
from the switch to access other devices in the network. Up to eight simultaneous Telnet sessions are
possible.
