21-46
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
78-13315-02
Chapter 21 Configuring Switch Access Using AAA
Configuring Authentication
To reset the 802.1x configuration parameters to the default values, perform this task in privileged mode:
This example shows how to reset the 802.1x configuration parameters to the default values and verify
the configuration:
Console> (enable)
clear dot1x config
This command will disable dot1x on all ports and take dot1x parameter values back to
factory defaults.
Do you want to continue (y/n) [n]?
Console> (enable)
show dot1x
PAE Capability Authenticator Only
Protocol Version 1
system-auth-control enabled
max-req 2
quiet-period 60 seconds
re-authperiod 3600 seconds
server-timeout 30 seconds
supp-timeout 30 seconds
tx-period 30 seconds
Using the show Commands
You can use these
show
commands to access information about 802.1x authentication and its
configuration:
•
show port dot1x help
•
show port dot1x
•
show port dot1x statistics
•
show dot1x
To display the usage options for the
show port dot1x
command, perform this task in normal mode:
This example shows how to display the usage options for the
show port dot1x
command:
Console> (enable)
show port dot1x help
Usage: show port dot1x [<mod[/port]>]
show port dot1x statistics [<mod[/port]>]
Task
Command
Step 1
Reset the 802.1x configuration parameters to the
default values and globally disable 802.1x.
clear dot1x config
Step 2
Verify the 802.1x configuration.
show dot1x
Task
Command
Display the usage options for the
show port
dot1x
command.
show port dot1x help
