R E V I E W D R A F T # 1 — C I S C O C O N F I D E N T I A L
A-29
Cisco WRP500 Administration Guide
Appendix A Advanced Voice Fields
Line page
•
“SIP Settings section” section on page A-32
•
“Call Feature Settings section” section on page A-34
•
“Proxy and Registration section” section on page A-34
•
“Subscriber Information section” section on page A-36
•
“Supplementary Service Subscription section” section on page A-37
•
“Audio Configuration section” section on page A-39
•
“Dial Plan section” section on page A-40
•
“FXS Port Polarity Configuration section” section on page A-41
In a configuration profile, the Line parameters must be appended with the appropriate numeral (for
example, [1] or [2]) to identify the line to which the setting applies.
Voice tab > Line page >
Line Enable section
Voice tab > Line page >
Streaming Audio Server (SAS) section
Line Enable
To enable this line for service, select yes. Otherwise, select no.
The default is
yes
.
SAS Enable
To enable the use of the line as a streaming audio source, select yes.
Otherwise, select no. If enabled, the line cannot be used for
outgoing calls. Instead, it auto-answers incoming calls and streams
audio RTP packets to the caller.
The default is
no
.
SAS DLG Refresh Intvl
If this value is not zero, it is the interval at which the streaming
audio server sends out session refresh (SIP re-INVITE) messages to
determine whether the connection to the caller is still active. If the
caller does not respond to the refresh message, the WRP500 ends
this call with a SIP BYE message. The range is 0 to 255 seconds (0
means that the session refresh is disabled).
The default is 30.
