R E V I E W D R A F T # 1 — C I S C O C O N F I D E N T I A L
A-3
Cisco WRP500 Administration Guide
Appendix A Advanced Voice Fields
Info page
Voice tab > Info page >
Line Status section
SIP Bytes Recv
Total number of bytes of SIP messages received (including
retransmissions).
External IP
External IP address used for NAT mapping.
Hook State
Hook state of the FXO port. Options are either On or Off.
Registration State
Indicates if the line has registered with the SIP proxy.
Last Registration At
Last date and time the line was registered.
Next Registration In
Number of seconds before the next registration renewal.
Message Waiting
Indicates whether you have new voice mail waiting. Options are
either Yes or No. The value automatically is set to Yes when a
message is received. You also can clear or set the flag manually.
Setting this value to Yes can activate stutter tone and VMWI signal.
This parameter is stored in long term memory and survives after
reboot or power cycle.
Call Back Active
Indicates whether a call back request is in progress. Options are
either Yes or No.
Last Called Number
The last number called from the FXO Line.
Last Caller Number
Number of the last caller.
Mapped SIP Port
Port number of the SIP port mapped by NAT.
Call 1 and 2 State
May take one of the following values:
•
Idle
•
Collecting PSTN Pin
•
Invalid PSTN PIN
•
PSTN Caller Accepted
•
Connected to PSTN
Call 1 and 2 Tone
Type of tone used by the call.
Call 1 and 2 Encoder
Codec used for encoding.
Call 1 and 2 Decoder
Codec used for decoding.
Call 1 and 2 FAX
Status of the fax pass-through mode.
