R E V I E W D R A F T # 1 — C I S C O C O N F I D E N T I A L
A-39
Cisco WRP500 Administration Guide
Appendix A Advanced Voice Fields
Line page
Voice tab > Line page >
Audio Configuration section
A codec resource is considered as allocated if it has been included in the SDP codec list of an
active call, even though it eventually may not be the one chosen for the connection. So, if the
G.729a codec is enabled and included in the codec list, that resource is tied up until the end of the
call whether or not the call actually uses G.729a. If the G.729a resource is already allocated and
since only one G.729a resource is allowed per device, no other low-bit-rate codec may be allocated
for subsequent calls; the only choices are G711a and G711u. On the other hand, two G.723.1/G.726
resources are available per device.
Therefore it is important to disable the use of G.729a in order to guarantee the support of two
simultaneous G.723/G.726 codec.
VMWI Serv
Enable VMWI Service (FSK).
The default is
yes
.
Speed Dial Serv
Enable Speed Dial Service.
The default is
yes
.
Secure Call Serv
Enable Secure Call Service.
The default is
yes
.
Referral Serv
Enable Referral Service. See the
Referral Services Codes
parameter
for more details.
The default is
yes
.
Feature Dial Serv
Enable Feature Dial Service. See the
Feature Dial Services Codes
parameter for more details.
The default is
yes
.
Service Announcement
Serv
Enable Service Announcement Service.
The default is
yes
.
