Configuring the Wireless Network (Cisco RV180W)
Configuring Basic Wireless Settings
Cisco RV180/RV180W Administration Guide
69
3
the data packet and the output queue identifies the output queue in which the
packet is transmitted:
•
Voice (4) or Video (3)—High priority queue, minimum delay. Typically used to
send time-sensitive data such as video and other streaming media.
•
Best Effort (2)—Medium priority queue, medium throughput and delay. Most
traditional IP data is sent to this queue.
•
Background (1)—Lowest priority queue, high throughput. Bulk data that
requires maximum throughput and is not time-sensitive is typically sent to
this queue (FTP data, for example).
If you want to change the output queue for packets marked with a particular DSCP,
select the new output queue from the drop-down list.
STEP 7
Click Save.
Configuring Wireless Network (SSID) Scheduling
You can configure each of the four available wireless networks on the Cisco
RV180W to be active during certain times of the day. To configure the schedule for
a wireless network:
STEP 1
Choose Wireless > Basic Settings.
STEP 2
In the Wireless Basic Settings Table, check the box on the left of the wireless
network you want to configure.
STEP 3
Select the wireless network for which you want to create a schedule.
STEP 4
Click Edit SSID Scheduling.
STEP 5
Check the Enable box to allow you to create a schedule to make the network
active during certain times.
STEP 6
Enter the start and stop times for the network to be active.
STEP 7
Click Save.
Summary of Contents for RV180
Page 31: ...Introduction Configuration Next Steps Cisco RV180 RV180W Administration Guide 22 1 ...
Page 32: ...Introduction Configuration Next Steps Cisco RV180 RV180W Administration Guide 23 1 ...
Page 67: ...Configuring Networking Configuring IPv6 Cisco RV180 RV180W Administration Guide 58 2 ...
Page 68: ...Configuring Networking Configuring IPv6 Cisco RV180 RV180W Administration Guide 59 2 ...
