Configuring the Firewall
Configuring Advanced Firewall Settings
Cisco RV180/RV180W Administration Guide
99
4
STEP 3
Choose the Upstream Interface (WAN or LAN). Select the interface (LAN or WAN)
on which the IGMP proxy acts as a normal multicast client.
STEP 4
Click Save.
Configuring LAN (Local Network) Groups
You can create LAN groups, which are groups of endpoints that are identified by
their IP address. After creating a group, you can then configure actions, such as
blocked keywords in a firewall rule, that apply to the group.
(See
Configuring URL Blocking, page 86
.)
Adding a New LAN Group
To create a LAN Group:
STEP 1
Choose
Firewall
> Advanced Settings > LAN (Local Network) Groups.
STEP 2
Click Add.
STEP 3
Enter the group name; spaces and quotes are not supported. Click Save.
STEP 4
If the group consists of a single IP address, choose Single Address and enter the
address in the Start IP Address field. If the group consists of a range of IP
addresses, choose Address Range and enter the addresses in the Finish IP
Address fields.
STEP 5
Click Save.
Enabling Session Initiation Protocol Application-Level
Gateway (SIP ALG)
SIP ALG can rewrite information within SIP messages (SIP headers and SDP body)
making signaling and audio traffic possible between a client behind Network
Address Translation (NAT) and the SIP endpoint.
Summary of Contents for RV180
Page 31: ...Introduction Configuration Next Steps Cisco RV180 RV180W Administration Guide 22 1 ...
Page 32: ...Introduction Configuration Next Steps Cisco RV180 RV180W Administration Guide 23 1 ...
Page 67: ...Configuring Networking Configuring IPv6 Cisco RV180 RV180W Administration Guide 58 2 ...
Page 68: ...Configuring Networking Configuring IPv6 Cisco RV180 RV180W Administration Guide 59 2 ...
