Configuring Quality of Service (QoS)
Mapping CoS Settings to DSCP Values
Cisco RV180/RV180W Administration Guide
135
6
These values mark traffic types with higher or lower traffic priority depending on
the type of traffic.
STEP 4
Click
Save
.
To restore the default CoS settings, click
Restore Default
and, when prompted,
click
OK
. Then, click
Save
.
Mapping CoS Settings to DSCP Values
NOTE
Before you can map CoS settings to DSCP values, you must first enable the CoS to
Queue option.
See
Configuring CoS Settings, page 134
for more information.
To map CoS settings to DSCP values:
STEP 1
Choose
QoS
>
CoS Settings
>
CoS to DSCP
.
STEP 2
In the
CoS to DSCP
field, check
Enable
.
STEP 3
For each CoS priority level, enter the corresponding DSCP value (
0
–
63
). The
default value is
63
.
STEP 4
Click
Save
.
To restore the default CoS to DSCP mappings, click
Restore Default
and, when
prompted, click
OK
. Then, click
Save
.
Summary of Contents for RV180
Page 31: ...Introduction Configuration Next Steps Cisco RV180 RV180W Administration Guide 22 1 ...
Page 32: ...Introduction Configuration Next Steps Cisco RV180 RV180W Administration Guide 23 1 ...
Page 67: ...Configuring Networking Configuring IPv6 Cisco RV180 RV180W Administration Guide 58 2 ...
Page 68: ...Configuring Networking Configuring IPv6 Cisco RV180 RV180W Administration Guide 59 2 ...
