Viewing the Cisco RV180/RV180W Status
Viewing the System Summary
Cisco RV180/RV180W Administration Guide
164
8
WAN (Internet) Information (IPv4)
MAC Address
The MAC address of the WAN port.
Connection Time
The time duration for which the connection is up.
Connection Type
Indicates if the WAN IPv4 address is obtained
dynamically through a DHCP server, assigned
statically by the user, or obtained through a PPPoE/
PPTP/L2TP ISP connection.
Connection State
Indicates if the WAN port is connected to the
Internet service provider.
DHCP Server
The IP address of the DHCP server to which the
WAN port is connected.
Lease Obtained
The the time at which lease is obtained from the
DHCP server.
Lease Duration
The duration for which the lease remains active.
IP Address
The WAN Address of the device.
Subnet Mask
The subnet mask of the WAN port.
Gateway
The gateway IP address of the WAN port.
Primary DNS Server
The IP address of the primary DNS server.
Secondary DNS Server
The IP address of the secondary DNS server.
NAT (IPv4 Only Mode)
Indicates if the router is in NAT mode (enabled) or
routing mode (disabled).
Release/Renew
Visible if automatic configuration - DHCP is
connected as the Internet connection type. Click
Release to release the current IP address that was
assigned to your WAN port. Click Renew to obtain
a new IP address for your WAN port.
Connect/Disconnect
Visible if an Internet connection type other than
automatic (DHCP) has been chosen. Click Connect
to connect to the selected server. Click Disconnect
to disconnect from the server to which you are
connected.
Summary of Contents for RV180
Page 31: ...Introduction Configuration Next Steps Cisco RV180 RV180W Administration Guide 22 1 ...
Page 32: ...Introduction Configuration Next Steps Cisco RV180 RV180W Administration Guide 23 1 ...
Page 67: ...Configuring Networking Configuring IPv6 Cisco RV180 RV180W Administration Guide 58 2 ...
Page 68: ...Configuring Networking Configuring IPv6 Cisco RV180 RV180W Administration Guide 59 2 ...
