Configuring Quality of Service (QoS)
Configuring Profile Binding
Cisco RV180/RV180W Administration Guide
133
6
STEP 3
Enter this information:
STEP 4
Click Save.
STEP 5
To bind the profile to a traffic selector, see
Configuring Profile Binding, page 133
.
Configuring Profile Binding
After creating WAN QoS profiles, you must bind them to traffic selectors. The
Profile Binding Table displays the profiles you have added, along with the service
to which the profile applies, the traffic selector match type (IP address range, MAC
address, VLAN, DSCP, or SSID), and the profile to which the binding is matched (in
the “match configuration” field).
Adding a Profile Binding
To create a profile binding:
STEP 1
Choose QoS > Profile Binding.
STEP 2
In the
Available Profiles
field, choose a WAN QoS profile.
To create a profile, click
Configure Profile
. See
Configuring WAN QoS Profiles,
page 131
for more information.
STEP 3
From the
Service
drop-down menu, choose the service to which the profile
applies.
Name
Enter the name of the profile.
Priority
If the WAN QoS mode is set to
Priority
, choose the
priority level from the drop-down menu.
Minimum Bandwidth
Rate
If the WAN QoS mode is set to
Rate Limit
, enter the
minimum bandwidth rate (
1
to total WAN
bandwidth in Kbps).
Maximum Bandwidth
Rate
If the WAN QoS mode is set to
Rate Limit
, enter the
maximum bandwidth rate (
100
–
1000000
Kbps).
Summary of Contents for RV180
Page 31: ...Introduction Configuration Next Steps Cisco RV180 RV180W Administration Guide 22 1 ...
Page 32: ...Introduction Configuration Next Steps Cisco RV180 RV180W Administration Guide 23 1 ...
Page 67: ...Configuring Networking Configuring IPv6 Cisco RV180 RV180W Administration Guide 58 2 ...
Page 68: ...Configuring Networking Configuring IPv6 Cisco RV180 RV180W Administration Guide 59 2 ...
