Configuring Quality of Service (QoS)
Configuring WAN QoS Profiles
Cisco RV180/RV180W Administration Guide
132
6
STEP 3
When prompted to reset the previous priority or rate limit configuration, click
OK
.
STEP 4
Click Save.
Configuring Bandwidth Allocation Settings
To configure the WAN QoS bandwidth allocation settings:
STEP 1
Choose QoS > WAN QoS Profiles.
STEP 2
Under
Priority Bandwidth Allocation Settings
:
If the WAN QoS mode is set to
Priority
, enter this information:
Each one of these values specifies the percentage of the total bandwidth
(100 Mbps) allocated to these priority levels.
If the WAN QoS mode is set to
Rate Limit
, enter this information:
STEP 3
Click Save.
Adding WAN QoS Profiles
To add a WAN QoS profile:
STEP 1
Choose QoS > WAN QoS Profiles.
STEP 2
In the
WAN QoS Profile Table
, click Add.
High Priority
Enter a value between
61
(default) and
100
.
Medium Priority
Enter a value between
31
(default) and
60
.
Low Priority
Enter a value between
10
(default) and
30
.
Total WAN (Internet)
Bandwidth
Enter the total WAN bandwidth (
1
–
100
Mbps).
Summary of Contents for RV180
Page 31: ...Introduction Configuration Next Steps Cisco RV180 RV180W Administration Guide 22 1 ...
Page 32: ...Introduction Configuration Next Steps Cisco RV180 RV180W Administration Guide 23 1 ...
Page 67: ...Configuring Networking Configuring IPv6 Cisco RV180 RV180W Administration Guide 58 2 ...
Page 68: ...Configuring Networking Configuring IPv6 Cisco RV180 RV180W Administration Guide 59 2 ...
