Cisco MGX 8830, Configuration Manual

Page: 5 / 642

Contents
v
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
Configuring Clock Sources
2-30
Manually Configuring BITS Clock Sources
2-32
Enabling NCDP on a Node
2-34
Setting the LAN IP Addresses
2-36
Setting the Boot IP Address
2-36
Setting the Disk IP Address
2-39
Starting a CLI Session Through the LAN Port
2-41
Configuring for Network Management
2-42
Configuring the SNMP Trap Source IP Address
2-43
Configuring the SNMP Manager Destination IP Address
2-43
Configuring the Community String and General Switch Information
2-44
Verifying the Hardware Configuration
2-45
C H A P T E R
3
Provisioning PXM1E Communication Links
3-1
Quickstart Provisioning Procedures
3-2
Line Configuration Quickstart
3-2
ATM Trunk Configuration Quickstart
3-3
PNNI UNI Port Configuration Quickstart
3-5
SVC Configuration Quickstart
3-7
SPVC and SPVP Configuration Quickstart
3-8
PNNI Virtual Trunk Configuration Quickstart
3-9
BPX PNNI Trunk Configuration Quickstart
3-12
AINI Link Configuration Quickstart
3-14
IISP Link Configuration Quickstart
3-15
XLMI Link Configuration Quickstart
3-17
Cisco IGX Feeder to MGX 8830 or MGX 8850 (PXM1E) Configuration Quickstart
3-19
General PXM1E Configuration Procedures
3-21
Configuring the Card Mode
3-21
Setting Up Lines
3-22
Bringing Up Lines
3-22
Configuring Lines
3-23
Verifying Line Configuration
3-28
Configuring Inverse Multiplexing for ATM
3-28
Creating an IMA Group
3-29
Configuring an IMA Group
3-31
Adding an IMA Link to an IMA Group
3-35
Configuring IMA Links
3-36
Adding an IMA Port
3-37
Establishing Redundancy Between Two Lines with APS
3-40