Cisco MGX 8830, Configuration Manual

Page: 179 / 642

3-51
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
Chapter 3 Provisioning PXM1E Communication Links
General PXM1E Configuration Procedures
Step 4
To display a list showing the resource partition you have created, enter the following command:
mgx8830a.1.PXM.a > dspparts
Step 5 To display the configuration of a specific resource partition, note the interface and partition numbers and
enter the following command:
mgx8830a.1.PXM.a > dsppart < ifNum > < partId >
Table 3-10 describes the parameters for this command.
The following example shows the report provided by the dsppart command.
mgx8830a.1.PXM.a > dsppart 1 1
Interface Number : 1
Partition Id : 1 Number of SPVC: 0
Controller Id : 2 Number of SPVP: 0
egr Guaranteed bw(.0001percent): 1000000 Number of SVC : 0
egr Maximum bw(.0001percent) : 1000000
ing Guaranteed bw(.0001percent): 1000000
egr Maximum bw(.0001percent) : 1000000
min vpi : 0
max vpi : 4095
min vci : 1
max vci : 65535
guaranteed connections : 10000
maximum connections : 10000
Note Partition ID 1 is reserved for PNNI.
Note For more information on working with partitions, see the “ Managing PXM1E Partitions ” section in
Chapter 9, “Switch Operating Procedures.”
minConns Specifies the guaranteed number of connections. On the PXM1E UNI/NNI, the ranges
vary according to the line types, as follows:
•
For OC3, T3, and E3 lines, the range is 10-27000.
• For T1 and E1 lines, the range is 10-13500.
maxConns Specifies the guaranteed number of connections. On the PXM1E UNI/NNI, the ranges
vary according to the line types, as follows:
• For OC3, T3, and E3 lines, the range is 10-27000.
• For T1 and E1 lines, the range is 10-13500.
Table 3-10 Parameters for the addpart Command (continued)
Parameter Description