Cisco MGX 8830, Configuration Manual

Page: 227 / 642

4-7
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
Chapter 4 Preparing Service Modules for Communication
Selecting MPSM Interfaces and Services
Active/Active state, you must specify only the interface type because this card can simultaneously
support ATM and Frame Relay services on different ports. To configure MPSM interfaces and services,
use the cnfcdmode command as described in the following procedure.
Step 1
Establish a configuration session using a user name with SERVICE_GP privileges or higher.
Step 2 Enter the cnfcdmode command using the following format:
M8850_SF.7.PXM.a > cnfcdmode < slot > < interfaceType > < service >
Table 4-1 defines the parameters for this command. After you enter the cnfcdmode command, the card
resets and the status changes to Active/Active.
The following example shows how to configure an MPSM-8-T1E1 card to use a T1 interface and Frame
Relay services:
M8850_SF.7.PXM.a > cnfcdmode 28 1 1
You are about to configure MPSM in slot 28 to :
Service Type : Frame Interface Type : T1
Unknown line module back card present
cnfcdmode: Do you want to proceed (Yes/No)? y
After you set the interface type and service, the card resets. You can check the status with the dspcd
<slot> command. You can verify that the cnfcdmode command has been run by looking at the Inserted
Card row of the dspcd display. Before MPSM-8-T1E1 configuration, the Inserted Card row displays the
generic name MPSM-8T1E1. After configuration, the generic name changes to a specific name such as
MPSM-8T1-FRM.
Table 4-2 lists the card names and what they mean when they appear in the dspcd and
dspcds command displays. While the card is resetting, the status will be Empty Resvd. When the reset
is complete and the card is ready for provisioning, the status changes to Active.
Table 4-1 cnfcdmode Command Parameters
Parameter Description
slot Enter the number for the slot in which the MPSM card is installed.
interfaceType Enter a number from the following list that selects the interface type to be used with
the MPSM:
• T1 Interface = 1
• E1 Interface = 2
•
T3 Interface = 3
• E3 Interface = 4
service Enter a number from the following list that selects the service the MPSM will
support:
•
Frame Relay Service = 1
• ATM Service = 2
•
CES Service = 3
Note This parameter applies only to MPSM-8-T1E1 cards.