Cisco MGX 8830, Configuration Manual

Page: 454 / 642

9-90
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
Chapter 9 Switch Operating Procedures
Managing PXM1E and AXSM Card Diagnostics
To configure ATM cell layer parameters on an IMA group, enter the cnfatmimagrp command as
follows:
cnfatmimagrp -grp < bay.group > -sps <
PayloadScramble
> -ais < aisMode >
In the following example, the user enables payload scrambling and AIS on the ATM IMA group 14 on
the PXM1E in the lower bay.
Unknown.7.PXM.a > cnfatmimagrp -grp 2.14 -sps 1 -ais 1
Table 9-37 describes the parameters for the cnfimagrp command.
Enter the dspatmimagrp <bay.group> command to display whether AIS and payload scrambling are
enabled or disabled for an IMA group, as shown in the following example:
Satire.2.PXM.a > dspatmimagrp 2.1
GrpNum HCScoset PayloadScramble NullCellHdr NullCellPayload AIS
------- --------- --------------- ----------- --------------- -------
2.1 Enable Disable 0x00000001 6a Enable
Table 9-37 cnfatmimagrp Command Parameters
Parameter Description
-grp <bay.group> The bay number and the IMA group number.
•
bay: Enter 2 for the lower bay.
• grp: 1-16
Note
On the PXM1E, the bay number is always 2.
sps <PayloadScramble> Enable of disable payload scrambling. Default: enabled.
•
1 = enable
• 2 = disable
ais <aisMode> Enables or disables the alarm indication signal (AIS) mode. The
AIS is an all-ones signal that is transmitted instead of the normal
signal to maintain transmission continuity and to indicate to the
receiving terminal that there is a transmission fault that is located
either at the transmitting terminal or upstream from the transmitting
terminal.
•
1 = Enable AIS transmitting.
• 2 = Disable AIS transmitting.
Default = Enable