Cisco AS5300 Universal Access Server Software Configuration Guide
Running Setup for Cisco IOS Release 11.3(2)T
C-14
Note
If your access server is using a T1/PRI card, continue with the section “Continuing
the Setup Script for T1/PRI Cards” and if your access server is using a E1/PRI card,
continue with the section “Continuing the Setup Script for E1/PRI Cards.”
Continuing the Setup Script for T1/PRI Cards
This section continues the setup script for T1/PRI cards.
Step 1
Enter the letter corresponding to the ISDN switch type that matches your telco switch
type:
Do you want to configure ISDN switch type? [yes]:
The following ISDN switch types are available:
[a] primary-4ess
[b] primary-5ess
[c] primary-dms100
[d] primary-net5
[e] primary-ntt
[f] primary-ts014
Enter the switch type [b]:
Step 2
Press Enter to allow users to dial in via ISDN or analog modems:
Next, you will be prompted to configure controllers.
These controllers enable users to dial in via ISDN or analog modems.
Do you intend to allow users to dial in? [yes]:
There are 4 controllers on this access server. If you want to use
the full capacity of the access server configure all controllers.
Controller T1 0,1,..etc in software corresponds to Port 0,1,..etc
on the back of the access server.
PRI configuration can be configured to controllers all at once
based on your PRI controllers selection. Where as CAS configuration
will be configured individually for each controller.
Step 3
Enter the number of controllers you will be using for the PRI configuration:
Enter # of controllers, you will be using for PRI configuration [4]:
Configuring controller parameters:
Configuring controller T1 0:
Configuring PRI on this controller.
Configuring controller T1 1:
Configuring PRI on this controller.
Step 4
Set the CAS configuration options for the first controller you are configuring. First, enter
yes to set robbed-bit signaling on the controller:
Configuring controller T1 2:
Will you be using CT1 (robbed bit signaling) on this controller? [yes]:
Step 5
Enter your telco framing type:
The following framing types are available: esf | sf
Enter the framing type [esf]:
Summary of Contents for AS5300 - Universal Access Server
