Cisco AS5300 - Universal Access Server, Software Configuration Manual, Page: 73 / 198

Basic Configuration 3-39
Configuring Voice Network Data
Configuring Voice Network Data
Use the procedures in this section only if you have a VoIP feature card installed in your access server.
Configure the voice network data by creating a number expansion table to map (or associate)
individual extensions with their full E.164 telephone numbers.
Configure
Verify
To verify your voice network data configuration:
•
Enter the show dialplan number phone_number command to see how a phone number maps
to a dial-peer. In the following sample configuration, 3 maps to dial-peer 103.
dial-peer voice 103 voip
destination-p1408523
codec g711ulaw
session target ipv4:1.13.23.1
!
num-exp 6.... 310766....
!
The following example shows how to test this configuration.
5300# show dialplan number 31001
Macro Exp.: 14085231001
VoiceOverIpPeer103
tag = 103, destination-pattern = `1408523',
answer-address = `',
group = 103, Admin state is up, Operation state is up
Table 3-22 Configuring Voice Network Data
Step Command Purpose
1
5300> enable
Password: <password>
5300#
Enter enable mode (also called
privileged EXEC mode).
Enter the password.
You have entered enable mode when the
prompt changes to
5300#
.
2
5300# config term
Enter configuration commands, one per line. End
with CNTL/Z.
5300(config)#
Enter global configuration mode. You
have entered global configuration mode
when the prompt changes to
5300(config)#.
3
5300# num-exp 6.... 310766....
Create a number extension table where
the extension is 6 and the expanded
telephone number associated with the
access server is 310 766-xxxx.
Note: The dots (....) represent variables
in the telephone number.
4
5300(config-if)# Ctrl-Z
5300#
%SYS-5-CONFIG_I: Configured from console by
console
Return to enable mode.
This message is normal and does not
indicate an error.