Running Setup for Cisco IOS Release 11.2
Using Setup on Cisco IOS Releases 11.2 or 11.3(2)T C-3
TN3270 Emulation software.
Primary Rate ISDN software, Version 1.0.
Backplane revision 1
Manufacture Cookie is not programmed.
1 Ethernet/IEEE 802.3 interface(s)
1 FastEthernet/IEEE 802.3 interface(s)
48 terminal line(s)
4 Channelized T1/PRI port(s)
128K bytes of non-volatile configuration memory.
8192K bytes of processor board System flash (Read/Write)
4096K bytes of processor board Boot flash (Read/Write)
Notice: NVRAM invalid, possibly due to write erase.
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Step 3
When the following message appears, press Enter to accept the default entry (yes) in
square brackets:
Would you like to enter the initial configuration dialog? [yes]:
Step 4
When the following message appears, press Enter to see the current interface summary:
First, would you like to see the current interface summary? [yes]:
Any interface listed with OK? value "NO" does not have a valid configuration
Interface
IP-Address OK? Method Status
Protocol
Ethernet0
unassigned NO unset up
up
FastEthernet0 unassigned NO unset up
down
Step 5
Enter a host name for the access server (this example uses 5300):
Configuring global parameters:
Enter host name [Router]: 5300
The enable secret is a one-way cryptographic secret used
instead of the enable password when it exists.
Step 6
Enter an enable secret password. This password is encrypted (more secure) and cannot be
seen when viewing the configuration:
Enter enable secret: lab
The enable password is used when there is no enable secret
and when using older software and some boot images.
Step 7
Enter an enable password that is different from the enable secret password. This password
is not encrypted (less secure) and can be seen when viewing the configuration:
Enter enable password: guessme
Step 8
Enter the virtual terminal password, which prevents unauthenticated access to the router
through ports other than the console port:
Enter virtual terminal password: guessagain
Step 9
Respond to the following prompts as appropriate for your network:
Configure SNMP Network Management? [yes]:
Community string [public]:
Summary of Contents for AS5300 - Universal Access Server
