Cisco AS5300 - Universal Access Server, Software Configuration Manual, Page: 161 / 198

A P P E N D I X
Using Setup on Cisco IOS Releases 11.2 or 11.3(2)T C-1
C
Using Setup on
Cisco IOS Releases 11.2 or 11.3(2)T
This appendix contains instructions for running the setup script for systems containing Cisco IOS
Release 11.2 or 11.3 software.
Getting Started
Before you turn on the access server and begin to use the setup script in the System Configuration
dialog, make sure you have:
•
Already connected the cables to the access server
•
Configured your PC terminal emulation program for 9600 baud, 8 data bits, no parity, and 2 stop
bits
All configuration will be performed from your PC terminal emulation program window.
Complete these steps:
Note
If you make a mistake, you can exit and run the System Configuration dialog again. Press
Ctrl-c, and type setup at the enable mode prompt (
5300#
).
Step 1 Power ON the access server. The power switch is on the rear panel of the access server,
at the lower right corner, near the power cord.
Figure C-1 Power Switch Location
H10690
Power
switch
Universal access
server