Cisco AS5300 - Universal Access Server, Software Configuration Manual, Page: 178 / 198

Cisco AS5300 Universal Access Server Software Configuration Guide
Running Setup for Cisco IOS Release 11.3(2)T
C-18
Next, you will be prompted to configure controllers.
These controllers enable users to dial in via ISDN or analog modems.
Do you intend to allow users to dial in? [yes]:
There are 4 controllers on this access server. If you want to use
the full capacity of the access server configure all controllers.
Controller E1 0,1,..etc in software corresponds to Port 0,1,..etc
on the back of the access server.
PRI configuration can be configured to controllers all at once
based on your PRI controllers selection. Where as CAS configuration
will be configured individually for each controller.
Step 3 Enter the number of controllers you will be using for the PRI configuration:
Enter # of controllers, you will be using for PRI configuration [4]: 1
Configuring controller parameters:
Configuring controller E1 0:
Configuring PRI on this controller.
Step 4 Set the CAS configuration options for the first controller you are configuring. First, enter
yes to set channel-associated signaling on the controller:
Configuring controller E1 1:
Will you be using CE1 (channel associated signaling) on this controller? [yes]:
Step 5 Enter your telco’s framing type.
The following framing types are available: no-crc4 | crc4
Enter the framing type [crc4]:
Step 6 Enter your telco line code type:
The following linecode types are available: ami | hdb3
Enter the line code type [hdb3]:
Step 7 Enter the letter corresponding to the signaling type to support modem pooling over the E1
lines:
The following line signaling types are available:
[a] e&m-fgb
[b] e&m-fgd
[c] e&m-immediate-start
[d] fxs-ground-start
[e] fxs-loop-start
[f] sas-ground-start
[g] sas-loop-start
[h] r2-analog
[i] r2-digital
[j] r2-pulse
[k] p7
Enter the line signaling type [i]: