Cisco AS5300 - Universal Access Server, Software Configuration Manual, Page: 166 / 198

Cisco AS5300 Universal Access Server Software Configuration Guide
Running Setup for Cisco IOS Release 11.2
C-6
[c] primary-dms100
[d] primary-net5
[e] primary-ntt
[f] primary-ts014
Enter the switch type [b]:
Step 14 If you want users to be able to dial in via ISDN or analog modems, configure the
controllers:
Note All incoming calls to the access server are handled by the controllers, which route
calls to the appropriate place inside the access server for processing.
These controllers enable users to dial in via ISDN or analog modems.
Do you intend to allow users to dial in? [yes]:
There are 4 controllers on this access server. If you want to use the full
capacity of the access server configure all controllers.
Controller T1 0,1,..etc in software corresponds to Port 0,1,..etc
on the back of the access server.
Configuring controller T1 0:
Is this controller in use? [yes]:
Will you be using PRI on this controller? [yes]:
Would you like to enable multilink PPP? [yes]:
Note If you want to configure the access server for channelized T1, enter no to the
above prompt.
Configuring controller T1 1:
Is this controller in use? [yes]:
Will you be using PRI on this controller? [yes]:
Would you like to enable multilink PPP? [yes]:
Configuring controller T1 2:
Is this controller in use? [yes]:
Will you be using PRI on this controller? [yes]:
Would you like to enable multilink PPP? [yes]:
Configuring controller T1 3:
Is this controller in use? [yes]:
Will you be using PRI on this controller? [yes]:
Would you like to enable multilink PPP? [yes]:
When you have completed the initial configuration script, messages similar to the
following appear:
The following configuration command script was created:
hostname 5300
enable secret 5 $1$zxxT$YZMzUP1/wQvyLn5cWeyPu.
enable password guessme
line vty 0 4
password guessagain
snmp-server community public