Cisco AS5300 - Universal Access Server, Software Configuration Manual, Page: 112 / 198

Configuring Authentication
Cisco AS5300 Universal Access Server Software Configuration Guide 4-6
You can also specify additional protection for privileged EXEC mode:
•
Privilege levels for Cisco IOS commands
•
Privileged EXEC passwords for different privilege levels
•
Privilege levels for specific lines on the access server
•
Encrypt passwords using the service password-encryption commands
For more information about these security tools, refer to the Security Configuration Guide, available
online at
http://www.cisco.com/univercd/cc/td/doc/product/software/ios113ed/113ed_cr/secur_c/
Communicating Between the Access Server and the Security Server
This section describes the Cisco IOS software commands that enable the access server to
communicate with a security server. This process is similar for communicating with and
RADIUS servers.
If you are using local authentication, refer to the section “Enabling AAA Globally on the Access
Server,” later in this chapter.
If you are using a remote security server for authentication and authorization, you must configure
the security server before performing the tasks described in this chapter. The section “Security
Examples” at the end of this chapter shows some typical and RADIUS server entries
corresponding to the access server security configurations.
8
5300(config)# Ctrl-Z
5300#
%SYS-5-CONFIG_I: Configured from console by
console
5300#
Return to enable mode.
This message is normal and does not
indicate an error.
9
5300# copy running-config startup-config
Save the configuration changes to
NVRAM so that they are not lost during
resets, power cycles, or power outages.
Table 4-2 Entering an Encryption Type (Continued)
Step Command Description