Cisco AS5300 - Universal Access Server, Software Configuration Manual, Page: 175 / 198

Continuing the Setup Script for T1/PRI Cards
Using Setup on Cisco IOS Releases 11.2 or 11.3(2)T C-15
Step 6 Enter your telco line code type:
The following linecode types are available: ami | b8zs
Enter the line code type [b8zs]:
Step 7 Enter the letter corresponding to the signaling type to support modem pooling over the T1
lines:
The following line signaling types are available:
[a] e&m-fgb
[b] e&m-fgd
[c] e&m-immediate-start
[d] fxs-ground-start
[e] fxs-loop-start
[f] sas-ground-start
[g] sas-loop-start
Enter the line signaling type [a]:
Step 8 Enter the tone signaling type:
The following tone signaling types are available: dtmf | mf
Enter the tone signal type [dtmf]:
Step 9 Press Enter to configure digital number identification service (DNIS) over T1 lines:
Do you want to provision DNIS address information? [yes]:
Step 10 Set the CAS configuration options for the next controller you are configuring.
Configuring controller T1 3:
Will you be using CT1 (robbed bit signaling) on this controller? [yes]:
The following framing types are available: esf | sf
Enter the framing type [esf]:
The following linecode types are available: ami | b8zs
Enter the line code type [b8zs]:
The following line signaling types are available:
[a] e&m-fgb
[b] e&m-fgd
[c] e&m-immediate-start
[d] fxs-ground-start
[e] fxs-loop-start
[f] sas-ground-start
[g] sas-loop-start
Enter the line signaling type [a]: b
After you complete the configuration script, messages similar to the following appear:
Current configuration:
version 11.3
no service password-encryption
!
hostname Router
!
enable secret 5 $1$BzCj$3WnJoC.GO0SmB2U7Bd.Kb1
enable password b
!
no ip routing
isdn switch-type primary-5ess
!
!
controller T1 0
framing esf
clock source line primary