Cisco AS5300 - Universal Access Server, Software Configuration Manual, Page: 150 / 198

Cisco AS5300 Universal Access Server Software Configuration Guide
Upgrading Modem Code
A-24
Step 2
In the HyperTerminal dialog box (see the previous section “Establish a HyperTerminal
Session,” for details), enter the access server enable mode (the prompt is displayed as
5300#
):
5300> enable
Password: <password>
5300#
Step 3
Enter the ping command with your PC’s IP address.
5300# ping 172.16.1.1
The access server displays five exclamation points (!) if everything is working and it
displays five dots (.) if there is a problem. In the latter case, check the cabling between
the router and the PC and check the access server configuration.
Upload Modem Code to the Access Server
The procedure for copying the modem code file from your PC set up as a local TFTP server to the
access server system Flash memory is a two-step process:
•
Transfer the modem code to the access server.
•
Transfer the modem code to the modems.
Perform these two steps only once. After you copy the modem code file into system Flash memory
for the first time, you should not have to perform these steps again. Because the code runs from
modem RAM, the Cisco IOS software must automatically copy the modem code to each modem
each time the access server power cycles.
The following code examples show a download to MICA modems. Use the same steps to download
to Microcom modems.
Step 1 Check the image in the access server Flash memory:
5300# show flash
System flash directory:
File Length Name/status
1 4530624 c5300-js-mx
[498776 bytes used, 16278440 available, 16777216 total]
16384K bytes of processor board System flash (Read/Write)
Step 2 Enter the copy tftp flash command to download the code file from the TFTP server into
the access server Flash memory. You are prompted for the download destination and the
remote host name.
5300# copy tftp flash
System flash directory:
File Length Name/status
1 4530624 images/c5300-js-mx
[498776 bytes used, 16278440 available, 16777216 total]
Address or name of remote host [255.255.255.255]? jurai
Source file name? mica-modem-portware.x.x.x.x.bin
Destination file name [mica-modem-portware.x.x.x.x.bin]?
Accessing file 'mica-modem-portware.x.x.x.x.bin' on 255.255.255.255...
Loading mica-modem-portware.x.x.x.x.bin from 2.2.0.1 (via Ethernet0): ! [OK]
Erase flash device before writing? [confirm] no
Copy 'mica-modem-portware.x.x.x.x.bin' from server
as 'mica-modem-portware.x.x.x.x.bin' into Flash WITHOUT erase? [yes/no] yes
Loading images/mica-modem-portware.x.x.x.x.bin from 2.2.0.1 (via Ethernet0):
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
[OK - 249108/16278440 bytes]
Verifying checksum... OK (0xE009)
Flash device copy took 00:00:02 [hh:mm:ss]