Chapter 2 Setting Up the Cisco Unified IP Conference Station 7936
Installing the Cisco Unified IP Conference Station 7936
2-16
Cisco Unified IP Conference Station 7936 Administration Guide
OL-10751-01
Using External Devices with Your Cisco Unified IP Phone
Refer to this information when using external devices with your
Cisco Unified IP Phone.
•
Depending on the quality of these devices and their proximity to other
devices such as mobile phones or two-way radios, some audio noise may
still occur. In these cases, Cisco recommends that you take one or more of
the following actions:
–
Move the external device away from the source of the RF or AF signals.
–
Route the external device cables away from the source of the RF or AF
signals.
–
Use screened cables for the external device, or use cables with a better
screen and connector.
–
Shorten the length of the external device cable.
–
Apply ferrites or other such devices on the cables for the external
device.
•
Cisco cannot guarantee the performance of the system because Cisco has no
control over the quality of external devices, cables, and connectors. The
system will perform adequately when suitable devices are attached using
good quality cables and connectors.
Installing and Connecting to the Network
You must connect the Cisco Unified IP Conference Station to the network and to
a power source before using it.
Refer to
Figure 2-1 on page 2-17
and
Figure 2-2 on page 2-18
when you are
installing the Cisco Unified IP Conference Station.
•
Figure 2-1
shows the various components and power and cable connections
used on the Cisco Unified IP Conference Station 7936.
•
Figure 2-2
shows the optional, external microphones and their connection to
the external microphone jacks on the underside of the
Cisco Unified IP Conference Station 7936.
