Smartport
Error Handling
Cisco 350XG & 550XG Series 10G Stackable Managed Switches
202
11
Error Handling
When a smart port macro fails to apply to an interface, you can examine the point
of the failure in the
page and reset the port and reapply the
macro after the error is corrected from the
page.
Default Configuration
Smartport is always available. By default, Auto Smartport is enabled by Auto
Voice VLAN, relies on both CDP and LLDP to detect attaching device's Smartport
type, and detects Smartport type IP phone, IP phone + Desktop, Switch, and
Wireless Access Point.
See
for a description of the voice factory defaults.
Relationships with Other Features
Auto Smartport is enabled by default and may be disabled. Telephony OUI cannot
function concurrently with Auto Smartport, and Auto Voice VLAN. Auto Smartport
must be disabled before enabling Telephony OUI.
Common Smartport Tasks
This section describes some common tasks to setup Smartport and Auto
Smartport.
Workflow1: To globally enable Auto Smartport on the device, and to
configure a port with Auto Smartport, perform the following steps:
STEP 1
To enable the Auto Smartport feature on the device, open the
page.
Set Administrative Auto Smartport to
Enable
or
Enable by Voice VLAN
.
STEP 2
Select whether the device is to process CDP and/or LLDP advertisements from
connected devices.
STEP 3
Select which type of devices are to be detected in the
Auto Smartport Device
Detection
field.
