Quality of Service
QoS Advanced Mode
Cisco 350XG & 550XG Series 10G Stackable Managed Switches
582
26
•
Ingress Committed Information Rate (CIR)
—Enter the CIR in Kbps. See a
description of this in the Bandwidth page.
•
Ingress Committed Burst Size (CBS)
—Enter the CBS in bytes. See a
description of this in the Bandwidth page.
•
Exceed Action
—Select the action assigned to incoming packets exceeding
the CIR. The options are:
-
None
—No action.
-
Drop
—Packets exceeding the defined CIR value are dropped.
-
Out of Profile DSCP
—IP packets exceeding the defined CIR are
forwarding with a new DSCP derived from the Out Of Profile DSCP
Mapping Table.
STEP 7
Click
Apply
.
Policy Binding
The Policy Binding page shows which policy profile is bound and to which port.
When a policy profile is bound to a specific port, it is active on that port. Only one
policy profile can be configured on a single port, but a single policy can be bound
to more than one port.
When a policy is bound to a port, it filters and applies QoS to ingress traffic that
belongs to the flows defined in the policy. The policy does not apply to traffic
egress to the same port.
To edit a policy, it must first be removed (unbound) from all those ports to which it
is bound.
NOTE
It is possible to either bind a port to a policy or to an ACL but both cannot be bound.
To define policy binding:
STEP 1
Click
Quality of Service
>
QoS Advanced Mode
>
Policy Binding
.
STEP 2
Select a
Policy Name
and
Interface Type
if required.
STEP 3
Click Go. The policy is selected.
STEP 4
Select the following for the policy/interface:
•
Binding
—Select to bind the policy to the interface.
