![Cisco 350XG series Administration Manual Download Page 214](http://html.mh-extra.com/html/cisco/350xg-series/350xg-series_administration-manual_67491214.webp)
Smartport
Configuring Smartport Using The Web-based Interface
Cisco 350XG & 550XG Series 10G Stackable Managed Switches
205
11
Configuring Smartport Using The Web-based Interface
The Smartport feature is configured in the Smartport > Properties, Smartport
Type Settings and Interface Settings pages.
For Voice VLAN configuration, see
For LLDP/CDP configuration, see the
sections, respectively.
Properties
To configure the Smartport feature globally:
STEP 1
Click
Smartport > Properties
.
STEP 2
Enter the parameters.
•
Administrative Auto Smartport
—Select to globally enable or disable Auto
Smartport. The following options are available:
-
Disable—
Select to disable Auto Smartport on the device.
-
Enable—
Select to enable Auto Smartport on the device.
-
Enable by Auto Voice VLAN—
This enables Auto Smartport, but puts it in
operation only when Auto Voice VLAN is also enabled and in operation.
Enable by Auto Voice VLAN is the default.
•
Operational Auto Smartport
—Displays the Auto Smartport status.
•
Auto Smartport Device Detection Method
—Select whether incoming
CDP, LLDP, or both types of packets are used to detect the Smartport type
of the attaching device(s). At least one must be checked in order for Auto
Smartport to identify devices.
•
Operational CDP Status
—Displays the operational status of CDP. Enable
CDP if Auto Smartport is to detect the Smartport type based on CDP
advertisement.
•
Operational LLDP Status
—Displays the operational status of LLDP. Enable
LLDP if Auto Smartport is to detect the Smartport type based on LLDP/
LLDP-MED advertisement.