Chapter 6 FIPS Operation
Using FIPS Mode
6-4
Cisco 11000 Series Secure Content Accelerator Configuration Guide
78-13124-06
Note
Passwords are not echoed to the screen. These passwords are
not FIPS-specific and are prompted for when the device is
used in normal operation.
b.
If the previously set access-level password is not appropriate for FIPS
Mode operation, the following text is displayed:
Your current access-level password is not valid for FIPS mode.
You need to provide an access-level password of at least 8
characters.
Enter new password:
Confirm password:
c.
If the previously set enable-level password is not appropriate for FIPS
Mode operation, the following text is displayed:
Your current enable-level password is not valid for FIPS mode.
You need to provide an access-level password of at least 8
characters.
Enter new password:
Confirm password:
d.
If both the previously set access- and enable-level passwords are valid for
FIPS Mode operation, no additional text is displayed.
5.
The device reboots and enters FIPS Mode. Enter the access-level password to
control the device.
Enter the access-level password:
Caution
If you cannot remember the passwords, you will not be able to view
device status and statistics or configure the device. The only option
is to use the “FailSafe” password as described in “Factory Default
Reset Password” section on page 4-4. All configuration will be
lost!
6.
Use the enable-level password to enter Privileged Mode.
Enter the enable-level password:
