5-3
Cisco 11000 Series Secure Content Accelerator Configuration Guide
78-13124-06
Chapter 5 Graphical User Interface Reference
Restricting Access to Web Management
The default TCP service port is 80. If you change it with the web-mgmt port
command, you must use that port to connect with the device via the Web browser.
Enter show device to check the state. The status should be listed similar to the
following:
...
Web Management: enabled on port 80
...
Restricting Access to Web Management
We recommend that you restrict Web management access to the Secure Content
Accelerator. Create one or more access lists using either the CLI (see “Example:
Restricting Access using an Access List” in Chapter 4) or the GUI (as described
later in this chapter.)
Starting the GUI
Follow these steps to use the GUI to manage the Secure Content Accelerator.
1.
Launch the Web browser.
2.
When configuring a device in dual-port mode from a computer via the
“Server” port, enter the SSL appliance IP address in the Address text box and
press Return or Enter. If an enable password has been defined on the device,
you are prompted for an user name and the enable password, as shown in
Figure 5-1. Use “admin” for the user name. If no enable password has been
configured, the GUI starts at the General content area.
