C-9
Cisco 11000 Series Secure Content Accelerator Configuration Guide
78-13124-06
Appendix C Command Summary
Initiating a Management Session
Initiating a Management Session
Use the appropriate instructions below to initiate a management session with the
Secure Content Accelerator.
Serial Management and IP Address Assignment
Follow these steps to initiate a management session via a serial connection and set
an IP address for the device.
Note
The default terminal settings on the SSL devices and modules is 80
columns by 25 lines. To ensure the best display and reduce the
chance of graphic anomalies, please use the same settings with the
serial terminal software. The device terminal settings can be
changed, if necessary. Use the standard ANSI setting on the serial
terminal software.
Note
When operating in FIPS Mode, only serial management access of
available.
1.
Attach the included null modem cable to the appliance port marked
“CONSOLE”. Attach the other end of the null modem cable to a serial port
on the configuring computer.
2.
Launch any terminal emulation application that communicates with the serial
port connected to the appliance. Use these settings: 9,600 baud, 8 data bits,
no parity, 1 stop bit, no flow control.
3.
Press Return. Initial information is displayed followed by an
SCA>
prompt.
4.
Enter Privileged and Configuration modes and set the IP address using the
following commands. Replace the IP address in the example with the
appropriate one.
SCA> enable
SCA# configure
(config[SCA])# ip address 10.1.2.5
(config[SCA])#
