CipherLab 2564MR, User Manual

Page: 264 / 283

2564MR Barcode Scanner User Guide
1) Connect the interface cable, RS-232 or USB, between the cradle and your computer.
For USB Virtual COM, you may need to install its driver first!
2) Connect the power supply cord from the cradle to a proper power outlet.
The Communication LED will indicate when the cradle can accept serial commands after
initializing. Refer to the table below.

If the output interface is USB Virtual COM or RS-232, run HyperTerminal.exe on your
computer. While the Communication LED on the cradle is purple (red with flashing
blue), type the serial command within three seconds.

If the output interface is USB HID, press the “Num Lock” or “Caps Lock” key on your
keyboard 5 times within 3 seconds while the Communication LED on the cradle is
flashing red and blue. This will change the interface from USB HID to USB Virtual
COM and the Communication LED will become purple (red with flashing blue). Then,
run HyperTerminal.exe on your computer. While the Communication LED on the
cradle is purple (red with flashing blue), type the serial command within three
seconds. After configuring via serial commands, the interface will be reset to USB
HID after re-connecting the power supply cord.
Communication LED Meaning
--- Blue,
solid
Initialize
Red,
solid
Blue,
flashing
Serial command mode with USB Virtual COM or RS-232: wait 3 seconds for
starting a serial command
Red,
flashing
Blue,
flashing
Serial command mode with USB HID changed to USB Virtual COM first: wait 3
seconds for pressing [Num Lock] or [Caps Lock] 5 times via keyboard
258
Enter Setup