Christie Mirage S+, User Manual

Page: 117 / 169

MAINTENANCE
Roadster/Mirage S+ User’s Manual
4-5
The IR Remote Keypad uses two AA size, 1.5V batteries (preferably alkaline). To
install new batteries:
1) Open the battery
compartment at the
backside of the keypad by
placing your thumb in the
oval depression and sliding
the cover out about ½ inch.
See Figure 4.1. Remove the
old batteries and properly
discard. Wait a minute or
two.
2) Place the new batteries in the
compartment, orienting the
positive/negative of each battery according to the labels in the compartment. When
the batteries are in place, replace the cover by placing the cover ½ inch from its
closed position and slide it into place. Do not force the cover.
NOTE: Always wait a minute or two when replacing batteries so that the internal
electronics discharge and can recognize the change.
For this procedure you will need the appropriate Roadster S+12K, Roadster
S+16K/Mirage S+14K or Roadster S+20K Lamp and Filter Replacement Kit
manufactured by Christie Digital Systems. See Table 4.2 below.
Table 4.2. Lamp and Filter Kits
Projector Model Lamp Type (Watts) Lamp/Filter Kit Required
Roadster S
+
12K (
38-DSP210-02
)
(
38-DSP210-52
)
2.0kW
03-900519-01P
03-900519-51P
Roadster S
+
16K (
38-DSP214-03
)
(
38-DSP214-53
)
03-900518-01P
03-900518-51P
Mirage S
+
14K (
38-DSP214-04
)
(38-DSP214-54
)
2.4kW
03-900518-01P
03-900518-51P
Roadster S
+
20K (
104-001001
)
(
104-001101)
3.0kW
003-000306
003-000306-02
A bubble lamp permanently mounted inside its own protective assembly provides the
high brightness of your projector. Using this module beyond its warranted life is not
recommended—changes in the quartz of the bulb can lead to reliability problems,
poor performance or sudden lamp expiry. The filter should always be changed when
the lamp is replaced, or sooner in dusty environments.
The lamp module is calibrated for maximum performance and brightness in this
projector. Do not attempt to re-align or adjust the lamp module.
4.3 Replacing
Keypad
Batteries
4.4 Replacing the
Lamp and Filter
Figure 4.1. Replacing Batteries