![background image](http://html1.mh-extra.com/html/christie/mirage-s/mirage-s_user-manual_2604023120.webp)
MAINTENANCE
4-8
Roadster/Mirage S+ User’s Manual
6. INSERT THE NEW LAMP MODULE
Align the base plate of the new lamp module under both side alignment guides
(see right). Slide the
module fully into the
projector in the same
orientation you removed
the old lamp module. Push
with normal force until the
resistance increases, then
firmly push module
another ½ inch.
NOTE:
The lamp module
must make
full contact
with the lamp connectors. Increased resistance when sliding the module in
indicates initial contact with these connectors—push firmly at this point.
WARNING
Improper installation could cause a serious
meltdown inside the projector.
7. RE-INSTALL LAMP RETAINING BAR
Position the retaining bar along the bottom edge of the lamp module, with its
ends under the alignment guides. If the bar does not fit, push the lamp module
further in. See Figure 4.5.
IMPORTANT
The tightening order of the screws is
critical for proper lamp
contact
and
alignment
.
Secure screw
B
until just engaged.
Secure screw
A
until just engaged.
Go back and forth between
A
and
B
to lock the bar in place with even
pressure and correctly position the lamp module.
Figure 4.5. Install Retaining Bar
Summary of Contents for Mirage S+
