Christie Mirage S+, User Manual

Page: 8 / 169

INSTALLATION & SETUP
2-2
Roadster/Mirage S+ User’s Manual
◊
The Roadster S
+
12K requires 200-240 VAC, 50-60 Hz, 12 amps @ 200 VAC.
◊
The Roadster S
+
16K and the Mirage S
+
14K require 200-240 VAC, 50-60 Hz, 16
amps @ 200 VAC.
◊
The Roadster S
+
20K requires 200-240 VAC, 50-60 Hz, 24 amps @ 200 VAC.
WARNING
Do not attempt operation if the AC supply and cord are not
within the specified voltage and power range. See Section 6 .
Turn On the Projector and Lamp
1. On the projector, turn the power
breaker/switch on. The LCD Status
Display Window displays the
initializing window for 15 seconds,
then indicates
POWER OFF
(see
right).
2. Using the keypad, do one of the
following:
• Press and hold briefly to
toggle the lamp on.
• Press and release followed
immediately by .
• Press to toggle from the
off state.
The LCD Status Display Window
will display
Powering Up and
then, Power On (Figure 2.1) while
the 2 Digit Status/Error Code
Window will display
ON .
Select a Source
Using either keypad, press
Input 1
,
Input 2
,
Input 3
,
Input 4
,
Input 5
, or
Input 6
to select and display
the image for the source you connected in Step 2. The display will resize as needed,
producing an image as large as possible for the type of source present.
Optimize the Display
Press
Auto
Setup
on the built-in keypad (or on the remote keypad) to initiate an
automated process in which the projector optimizes critical display parameters such as
size, position, pixel tracking, etc., for the current source.
Auto Setup can save time in
perfecting a display, and you can modify the adjustments later as desired. See Section 3.
STEP 4
'
Figure 2.1. Turning on the projector
STEP 5
'
STEP 6
'