![background image](http://html1.mh-extra.com/html/christie/mirage-s/mirage-s_user-manual_2604023026.webp)
INSTALLATION & SETUP
2-20
Roadster/Mirage S+ User’s Manual
INPUT 3
and
INPUT 4
provide simultaneous connection of both a composite video
source (
INPUT 3
) and an S-Video source (
INPUT 4
). See Figure 2.27 below.
Figure 2.27. Connecting Composite Video
Christie’s
Dual SD/HD-SDI
input module is standard with the
Roadster S+
and
factory-installed in
INPUT 5
or
INPUT 6
. The module’s loop-through capability
enables incoming serial digital data to be tiled across multiple screens, creating vast
“mega resolution” displays. Alternatively, the multiple outputs can be overlapped for
extra-bright displays, or simply distributed to additional projectors for multiple
screens of the same image.
The module accepts one or two independent standard- or high-definition serial digital
inputs, decodes them for processing in the main electronics of the projector, and
outputs 10-bit YCbCr 4:2:2 video. Either input can be set as the active primary or
secondary part of a Picture-in-Picture display, and either input can be looped through
to one (or both) of the module’s BNC outputs.
NOTE:
Selection of these inputs is described in
3.3, Using the Keypads
.
Connect a compatible SMPTE 292M or SMPTE 259M-C source(s) to one or both of
the inputs located on the left side of the module. The module will automatically
detect the standard at each input and configure itself accordingly for correct
termination of the signal. The module also detects and supports dual link 292M and
SMPTE 372M video standards. For full details, consult the
Dual SD/HD-SDI
manual.
Optional modules allow you to increase your total number of inputs and/or
accommodate different signal types, whether analog or digital. Install in the areas
labeled
INPUT 6
or (if available)
INPUT 5.
Options include:
•
RGB 500 Input Module
•
RGB 400BA Input Module
•
RGB 400 Active Loop Thru Input Module
•
Composite/S-Video Input Module
(
not currently supported with
software v1.1 or higher)
•
PC250 Analog Input Module
•
Serial Digital Input Module
•
DVI Input Module
•
Dual SD/HD-SDI Module
(standard on the Roadster series)
For even more sources, connect a 3
rd
-party switcher to the RS232 IN port, or, if
RS422-compatible, connect to the RS422 port.
Composite Video
'
Dual
SD/HD-SDI
'
Other Optional Inputs
'
Summary of Contents for Mirage S+
