Christie CP2000-SB, User Manual

Page: 81 / 203

3-36 CP2000-SB User Manual
020-100162-06 Rev. 1 (03-2014)
Section 1: Introduction
Table 3.14 Admin: Source Menu Options
RESOLUTION NOTES:
To capture/process all of the incoming data , enter the full resolution of the incoming source material or leave at
0 (default). Regardless of whether or not the original material has been squeezed for use with an auxiliary lens,
enter the current incoming resolution. This may not necessarily match the resolution of the projector or the
original filmed material, depending on how the source was formatted before distribution. For example, an
original 2048 x 1080 native source supplied pre-squeezed as 1920 x 1080 requires a source file indicating this
incoming 1920 x 1080 resolution.
To capture only a portion of an incoming image full-screen-like a zoom function -, enter the approximate
horizontal width and vertical height defining the area of the image you wish to zoom in on. The projector will
automatically scale a center area of this size so that it fills the projector's 2048 x 1080 display, and remaining
data is ignored. You may have to experiment with the values to accurately zoom in on a precise area, and you
must also define offset (see below) if you want to zoom in on an area other than the center.
ADMIN: SOURCE MENU OPTIONS
Resolution Activate, then record the x/y resolution of your incoming signal, such as 2048 (x) and
1080 (y), or 1920 (x) and 1080 (y). Note that resolution must match the incoming signal
format (assuming you want to display all of it), and may differ from the original resolution
that you want to recover. See Resolution Notes below.
Offset Activate, then record how much incoming data you wish to discard, essentially delaying
the starting point for processing. Leave at 0 to process all available data. See Offset Notes
below.
Aspect Ratio Enter the aspect ratio of the original cinema format you are trying to recover, usually 2.39
or 1.85. Because the incoming signal may be pre-squeezed, the aspect ratio entered here
will not necessarily match that of the incoming aspect ratio. See Aspect Ration Notes
below.
Slidebars Adjust resolution and/or offset as desired.
Create Source Save current resolution, offset, and aspect ration settings as a Source file that will be
accessible and applied from within the Custom menu.
Restore Cancel new (unsaved) source settings of resolution/offset/aspect ratio.
Test Apply current settings to the image without saving.