3-64
CP2000-SB User Manual
020-100162-06 Rev. 1 (03-2014)
Section 1: Introduction
3.9
Working with the Lens
The
CP2000-SB
lens mount secures the primary zoom
lens to the projection head. It provides 1) setup
adjustments for correct boresight, and 2) automatically
controlled focus, zoom and offsets for general use. To
save the focus, offset and zoom settings to the channel,
you must make the adjustments using the motorized lens
mount adjustment features in the
Main: Lens
menu or
Custom: Lens
menu from the TPC. Using the knobs on
the lens mount to adjust each position does not save the
settings to the channel. They are designed for temporary
use and will therefore be lost once the channel changes.
NOTE
:
After any manual adjustment, click
Lens Reset
in
the
Advanced: Lens
menu to ensure ILS settings are
properly recalled.
An optional auxiliary lens (1.25x or 1.26x) can be
installed into an optional auxiliary lens mount, then
swung into place in front of the primary lens to widen a
squeezed image into a properly proportioned scope
anamorphic cinema display. It is typically used in theatres
having side masks that are retracted for scope images, or in theatres having fixed side masking but a very short
throw ratio (throw ratio= throw distance/screen width). To move the auxiliary lens, select the Anamorphic
Lens button on the
Main
menu of the TPC. Refer to
Section 2.8 Offset and Boresight Alignment
for all lens
installation and boresight instructions. Refer to
Section Custom: Lens Menu, on page 3-26
for ILS and channel
setup.
3.9.1 Lens Mount Functions
1) If the Motorized Auxiliary Lens
Mount (MALM) is present, ensure to move the MALM
to the OUT position before performing any lens
calibrate or reset functions on the Motorized Primary
Lens Mount to prevent collision between the
projection lens and the MALM. 2) Hazardous moving
parts. Keep fingers and other body parts away.
NOTES: 1)
Projector must be fully assembled and powered up
in its final location.
2)
Keep clear of rotating parts. Remotely
operated motors may start to spin without warning.
3)
Avoid
long hair, jewelry, and loose clothing exposure to the knobs
during manual adjustment.
4)
In case of emergency, unplug the
line cord to immediately halt movement of the lens mount.
5)
When adjusting the Focus, Offset, and Zoom, you may
experience a slight delay in the response rate of the lens upon selecting the buttons.
Zoom
From the
Main: Lens
menu, click the zoom in/out buttons to enlarge or shrink the image in each direction as
necessary.
Figure 3-53 Anatomy of the Lens Mount
Figure 3-54 Intelligent Lens System
Summary of Contents for CP2000-SB
