Christie CP2000-SB, User Manual

Page: 186 / 203

Section 1: Introduction
CP2000-SB User Manual B-13
020-100162-06 Rev. 1 (03-2014)
Simple Network Management (SNM) requires v2.7 or higher and TPC 60/66
Used for simple network management protocol setup
(SNM 0 “trap IP address”) To disable specify “0.0.0.0”
(SNM 1 OID) OID is either 11273 or 25766
Select Source Format (SRF)
(SRF “filename”) Select the stored source file defining incoming resolution and
desired aspect ratio for the current display.
(SRF?) What is the current source format?
(SRF!”1280x1024square”) Current source format filename is 1280x1024square.
Shutter Control (SHU)
(SHU 0)
(SHU 1) Open or close the electronic “quick douser”
0 = shutter open
1 = shutter closed
Source Change (SRC)
Same as CHA command
Stop TI Communication / Terminate TPC Application (STP)
0 = Start TI communication
1 = Stop TI communication
2 = Terminate TPC application
3 = Reboot TPC
System Status (SST)
Method of reading projector information. See Messages With
Multiple Parameters later in this Appendix.
Target Color Gamut (TCG)
(TCG “filename”) Select the stored target color gamut file to apply to the current
display.
(TCG?) What TCGD is currently in use?
(TCG!P7V2) The P7V2 TCGD is in use
3D Controls (TDC)
(TDC 1)
(TDC 10 420) Turn 3D controls ON/OFF or sets specific 3D controls
Example shown: Set dark time to 420
μ s
For all other 3D controls, see Messages With Multiple Parameters
later in this Appendix.
Time & Date (TMD)
(TMD 2003 08 13 14 21 00)
(TMD! 2003 08 13 14 21 00) Set/read the time and date in the projector’s real-time clock.
P1 = Year (yyyy)
P2 = Month (01-12)
P3 = Date (1-31, day of month)
P4 = Hour (0-23, 24hr clock)
P5 = Minute (0-59)
P6 = Second (0-59)
Function Code / Examples Description and Parameters