China Electronics Technology Instruments AV3672 Series, User Manual

Page: 306 / 424

10 Fault Diagnoses and Repair
10.3 Error Information
302
1032 Warning
The selected measurement is not found. Operation cannot be performed.
Conflict.
1033 Warning
Measurement of the same name cannot be created.
1034 Warning
The selected trace is not saved. Save the trace before trace operation.
The trace must be saved before trace operation.
1035 Prompt The averaging operation is completed.
COM programming information. The sweep averaging is completed, and the value
reaches the set average factor.
1036 Error
The sweep averaging of resetting is completed.
COM programming information. The sweep averaging is not completed, and the
value does not reach the set average factor.
1037 Prompt
At least three points are required for time domain transformation and gate
operation. If less than three points are provided, cancel the time domain
transformation and gate operation.
1038 Prompt
The stepping type must be used in the low-pass time domain measurement mode.
The band-pass must be used in the pulse stimulus type.
1039 Warning Smoothing cannot be done as a result of insufficient points.
1040 Warning If too may low-pass points in the time domain are beyond the frequency range,
the system will automatically change into the band-pass mode.
1041 Warning The low-pass frequency cannot be set in the current configuration.
1103 Prompt The measurement name is repeated.
1104 Error The number of measurements is out of limit.
At most 512 measurements can be created.
1105 Error
The parameter is invalid.
The measurement parameter entered in programming is invalid.
1106 Error
No measurement is found.
Conflict.
1107 Error
The saved trace is invalid and cannot be operated.
Save the trace before trace operation.
1108 Error No reference marker.
Try to create the
△
marker (only for COM) before creating the reference marker.
1109 Error The data and saved trace do not match with each other. The trace operation is
shut down.
Warning: channel settings are changed in trace operation.
1110 Error
The data and saved trace do not match with each other. Measurement conditions
of the memory and data traces should be similar in trace operation.
Try to perform trace operation on the mismatching data and memory trace.
1111 Error The marker bandwidth is not found.
The trace conforming to the specified bandwidth standard cannot be found.
1112 Error The peak value is not found.
The trace conforming to the specified peak standard cannot be found.
1113 Error The target search value is not found.
The interpolation data point conforming to the search value requirements is not
found.
1114 Error
One auxiliary port must be provided for reflection measurement (such as S11) to
clearly identify the Port 2 measurement of the multi-port device.
1115 Warning As a result of measurement type or source port changes, the receiver power
calibration is invalid and shut down.