SUSPENSION AND STEERING 237
SHIMS
SPECIAL THICK WASHER IS LOCATED AT REAR
INBOARD POSITION
UPPER
CONTROL
ARM
85 N-m (63 FT. LBS.)
Upper
control arm chassis mounting on 1984 and later models
Lower control arm assembly on 1984 and later
4. Hand-tighten all connections until the
bar and links are fully assembled.
5.
Tighten all connections, lower the ve
hicle, and bounce it a few times.
Stabilizer bar mounting
6. Raise the car and tighten all connec-
tions with a wrench.
Wheel Hub
REMOVAL AND INSTALLATION
1. To remove the wheel hub, snap off the
wheel covers and loosen the lug nuts, then
raise and secure the vehicle.
2. Remove the lug nuts, wheel and tire,
and brake drum or disc brake caliper.
3. Insert a wood spacer between die brake
calipers, on disc brake vehicles, and secure
the assembly out of the way.
4. Pry off the grease cap and extract the
cotter pin from the spindle nut. Back off the
spindle nut and washer, and remove the hub
65 N-m (48 FT. LBS.)
130 N-m (96 ft. Ibs.
KNUCKLE
ASSEMBLY
WELD NUTS
