CHASSIS ELECTRICAL 197
1963-67 windshield wiper motor and linkage
twining clip and disconnect both linkage and
spacer from the crank arm.
8. Remove the wiper motor-to-firewall
bolts and remove the motor.
9. To install, have an assistant aid in po
sitioning and mount the wiper motor to the
firewall. Ensure that the motor is in the
parked position.
10. Position the left linkage, spacer, and
right linkage on the crank arm and install the
retaining clip in the groove in the crank arm.
11. Install remaining parts in a reverse or
der of removal.
12. Connect battery and test wipers and
washers.
1968-82
1. Ensure that the wiper motor is in the
Park position.
2. Disconnect washer hoses and wire leads
from the motor.
3. Remove the plenum chamber grille.
4. Remove the crank arm-to-motor retain
ing nut.
5. Remove the ignition shielding and dis
tributor cap.
6. Remove the three, motor retaining
screws or nuts and remove the motor.
7. Check gaskets and replace if necessary.
Ensure that the motor is in Park position.
8. Reverse removal steps to install.
1984 and Later
1. Remove the wiper arms.
2. Remove the air inlet leaf screen.
3. Turn the ignition ON and activate the
wiper switch. Allow the motor to rotate the
crank arm to a position between 4 and 5 o'clock
as viewed from the passenger compartment.
Turn off the ignition to stop the crank arm in
this position.
4. Disconnect the negative battery cable.
5. Disconnect the upper motor electrical
connectors.
6. Remove te wiper motor mounting bolts.
7. With the crank arm in the position de
scribed above, the wiper motor may be easily
removed from the vehicle. Disconnect the
lower electrical connector as the motor is re
moved.
8. Installation is the reverse of removal.
Wiper Blades and Inserts
REMOVAL AND INSTALLATION
Refer to Chapter One for this information.
Wiper Transmission
REMOVAL AND INSTALLATION
1963-67
1. Remove the wiper block and arm as
sembly from the transmission.
2. Remove the glove box door and com
partment assembly.
3. Remove the three transmission-to-cowl
retaining screws.
4. Remove the wiper transmission retain
ing clip and remove the transmission from the
crank arm.
5. Remove the transmission through the
glove box opening.
6. To install, reverse the above proce
dure.
1968-72
1. Make sure the wiper is in the park po
sition.
2. Open the hood and disconnect the bat
tery ground cable.
1968-82 windshield wiper motor and linkage
