Chery Karry, User Manual, Page: 77 / 131

Emergency Procedures
77
Front fog lamp bulb
Please get to the Chery’s special service
station to replace the front fog lamp bulb.
Tail lamp bulb
Replace the corresponding bulb according
to the following steps if the tail lamp does
not work due to damage.
1. Open the back door and remove the
cover plate of rear compartment,
counterclockwise unscrew a nut that
fixes the tail lamp and then
counterclockwise unscrew three
bolts on the tail lamp surface, hold
the lamp and remove them, take out
the tail lamp about 8cm.
2. Remove the bulb holder
counterclockwise according to the
position as shown in the diagram,
put down the tail lamp and replace
the bulb.
3. Note: The surface of new bulb shall
not be touched by hand to prevent
effect on bulb brightness. The
lighting system is a safety
component, please ensure every
detail of replacement proper. Get to
the Chery’s special service station to
have it repaired if necessary.
License plate lamp bulb
Installation position: on the top of
rear license plate.
1. Unscrew the self-tapping screws that
fix the license plate and take them
out.
2. Draw out the bulb holder and take
the damaged bulb out.
3. Install a new bulb in the holder and
then install the holder.
4. Fix it with self-tapping screws.
Interior front ceiling lamp
bulb
1. Turn off the interior lights.
2. Insert the screwdriver in the gap
between the lamp housing and
lampshade, take out the lampshade