Chery Karry, User Manual, Page: 40 / 131

Introduction of Vehicle Functions & Instruction of Designation
40
Operation Method
Basic operation
Tape play
1
．
Turn the button 1 to the right and
connect with power supply, and
increase the volume properly.
2 ． Let the tape open side face to the
right and push in the tape
compartment 5 to locking position,
the machine is under play state.
Meanwhile, the display 4 shows
“TAPE” characters and tape direction
indication “
▲ ”“ ▼ ”.
3 ． Adjust the volume button 1 and tone
button 2 to make the volume
moderate and the tone clear and
sweet.
4 ． The tape can turn over automatically
when it runs to the end. You may
press forward and backward keys 6
and 7 simultaneously for manual turn.
5 ． In order to select the songs you want
to listen fast, you may press forward
key 7 or backward key 6 for rapid
advance or reverse, then slightly
press another backward key or
forward key once, the machine will
be under play state.
6
．
The directions “ ” or “ ” shown in
the display are the running direction
of tape. Right means clockwise and
left means counterclockwise.
7 ． If you want to stop play or need to
change the tape, press “out” key 3
and the tape will pop out the
compartment.
Listen to the radio
1. Power switch, volume control and
volume adjustment are the same as
“Tape Play”.
2. Press the “Frequency modulation/
amplitude modulation selection key”
13, the wave band to be received will
show on the display 4. You may select
one from FM1, FM2, FM3 and AM
depending on your demand.
3. Automatic, automatic tune (channel
selection):
（ 1 ） Instantaneously press Key 8 or Key
9 to fulfill manual tune, repeatedly
press the key till the wanted channel is
received.
（ 2 ） Constantly press Key 8 or Key 9 over
0.5 second, the machine shall complete
auto-tune. The tuning is ended after a
channel received. Repeat
（ 1 ） or （ 2 ） ,
you may receive the program you
wanted.
4. Automatic scan tune:
Instantaneously press SCN Key 11 to
realize auto-scan function, the machine
will automatically scan channels from the
frequency up to down. It will suspend
scanning when a channel is caught. The
channel frequency will flash for 5 seconds
and play the program of the channel. Then,
it will continue to scan the higher
frequency and automatically return when
it reaches the highest frequency. Then it
scans from the lowest frequency to the
highest again.
When you want to listen to a certain
channel, you only need to press SCN key
once as the channel frequency flashing.
The scan will stop at the channel position
immediately. It will resume the auto-scan