Chery Karry, User Manual, Page: 58 / 131

Introduction of Vehicle Functions & Instruction of Designation
58
The upper part may convert to display
digital clock and subtotal mileage.
The lower part shows the total mileage (in
6 digits, from 0-999999Km, shown as
999999 after exceeding the range.
The subtotal mileage displays in 4 digits
from 0-999.9 Km, starting again from
0.0Km after exceeding the range.
Adjusting method for clock as below:
Under the clock display state, it may
adjust the clock by long time (pressing > 2
seconds) the adjusting button on the
speedometer, click the button (pressing < 2
seconds) when the hour-position flickering.
Wait for at least 5 seconds after
hour-adjustment, the minute-position may
flash, adjust it by clicking the clock button
(pressing < 2 seconds), then wait for at
least 5 seconds and quit the clock
adjustment state.
Conversion method for digital clock and
subtotal mileage as follows:
When the ignition switch is at ON state,
click the adjusting button (pressing < 2
seconds) to convert the display between
digital clock and subtotal mileage. Under
the state of subtotal mileage display, press
the adjusting button (pressing >2 seconds)
to clear the subtotal mileage.
Engine tachometer
It shows the rotation speed of engine
(r.p.m). The red area in the right side of
dial means the maximum allowable
rotation speed range in short time for
run-in engine under working temperature.
However, it suggests that the transmission
lever shall be pushed to higher gear
position at latest when the hand reaches to
the area, or remove you foot from the
accelerator pedal.
Note:
Changing to higher gear position earlier is
good for saving fuel and reducing driving
noise.
Once the engine operates unstable, please
change to the adjacent lower gear position
immediately.
DO NOT let the engine
running with high speed in
running-in period.