Chery Karry, User Manual, Page: 41 / 131

Introduction of Vehicle Functions & Instruction of Designation
41
if you press SCN key again.
5. The display 4 shows stereo symbol
“ST” when you are receiving stereo signal.
When you want to receive mono signal
program, you only need to press “MO”
key 14. Then the “ST” on the display is off
and the “MO” symbol is on.
Channel frequency memory
You may use 1-6 memory key of
Presetting Key 15 to pre-save
4 × 6
channel frequencies under FM1, FM2,
FM3 and AM states respectively.
1. Manual memory
When you have searched a channel by
auto-search, then press one of 1
×
6
memory keys for at least 3 seconds. When
the channel broadcast is from strong to
weak and then strong, the channel
frequency has been saved in the memory
you pressed.
2. Automatic memory
Constantly press AS Key 10 at least 3
seconds at some wave band and the
machine enters in preset auto-selection
and save program; the display 4 shows
“ATP” character, the machine searches
channels from low frequency to high
automatically. It may automatically save 6
channels with stronger frequency from the
initial frequency. The machine may show
every channel frequency in circle after
saving and flash the memory code of
current channel for 5 seconds with the
broadcast of the channel. If you press AS
key 10 once more, the machine will show
the codes in circle. For wave bands FM1,
FM2, FM3 and AM, it can fulfill the
foresaid auto-save function.
Scan of saved channels
In a wave band, instantaneously press AS
key 10 once, the display 4 will show
already saved 6 channel frequencies in
turn. For every channel frequency, its
corresponding memory code of channel
address may flash for 5 seconds with the
broadcast of the channel. If you want to
listen to the program of a channel, you
may press the digital key (1-6 key)
corresponding to the memory code of the
channel address, the scan will stop at the
channel position. For wave bands FM1,
FM2, FM3 and AM, it can fulfill the
foreside scan of saved channels.
Other Functions
Loudness control
Press “LOU” key 12 at small volume
for high or low frequency tone
compensation. In the time, the display 4
appears “LOUD” character. Press the key
once more, the loudness does not act and
the “LOUD” character is off.
Front/ rear, left/right control
1. Outer turn button 16 is used for control
the volume of front and rear speakers.
A. The outer turn button is set at
balanced position as the machine
ex-factory. The volume for front and
rear speakers is the same while
operating the machine.
B. According to your demand, please
turn the outer turn button clockwise
to the maximum position if you
want to turn off the rear speaker.
C. Please turn the outer turn button
counterclockwise to the maximum
position if you want to turn off the
front speaker.